DIN 41773 PDF

This specification does not concern legal or safety standards. 26/11/, 1/3. 1 Charging characteristic: IUa (according to DIN ). Regime. Switching. transformer, input PF , low input harmonics (DIN (UI). Find the most up-to-date version of DIN at Engineering

Author: Brakora Vugul
Country: Mozambique
Language: English (Spanish)
Genre: Travel
Published (Last): 9 June 2015
Pages: 92
PDF File Size: 19.27 Mb
ePub File Size: 8.71 Mb
ISBN: 684-8-57610-694-5
Downloads: 13912
Price: Free* [*Free Regsitration Required]
Uploader: Kirn

For the alternating-current system, see Three-phase electric power. This page was last edited on 24 Mayat If a battery is connected to a significant load during charging, the end of the Uo-phase may never be reached and the battery will gas and be damaged, depending on the charge current relative to the battery capacity.

The purpose is to fully charge the battery in a relatively short time without reducing its life span and to indefinitely keep the battery charged as long as the charger is connected. Views Read Edit View history.

The U o -phase is concluded when the charge current goes below a threshold I minafter which the U-phase is entered.

The voltage U o may be the same as U max in the previous stage, or it may be taken slightly higher. The charger limits the maximum voltage to U maxa constant or temperature-dependent maximum, typically around 2.

Related Articles (10)  BRODI ASHTON EVERNEATH PDF

This phase idn when an IUoU charger is connected to a deeply discharged battery. The three phases are: In practice, it depends on the capability of the charger.

From Wikipedia, the free encyclopedia. During this phase, the charge current decreases gradually to a small residual value that compensates for any self-discharge of the battery. Stage 1 is called the I-phaseconstant-current stagedln bulk charge stage. I-phase constant electric currentUo-phase constant over- voltageand U-phase constant voltage.

An issue of continuity

The charging current is a compromise between charging time favoring high currentsthe prevention of damage due to overheating or gassing favoring low currentsand cost of the charger favoring low currents. Stage 2 is called the U o -phaseconstant-voltage boost stageabsorption stageor topping charge. 441773 current in the I-phase stage 1 should be chosen depending on the capacity of the battery. IUoU is a DIN -designation [1] DIN for a lead-acid battery charging procedure that is also known as 3-stage charging3-phase chargingor 3-step idn.

The voltages in the U and U o phases stages 2 and 3 depend on the type of battery and the temperature. It consists of three phases or stagesto be executed by a battery charger. Batteries have varying numbers of cells typically six for an automotive battery and may be flooded-cell, absorbed-glass-matt AGMor gel-electrolyte types. As a result of the current, the battery absorbs the charge and its voltage rises.

Related Articles (10)  LEIRIS MANHOOD PDF

A bad battery will have short I-phase and Uo-phase, but there is a risk of gassingfurther damaging the battery. Retrieved from ” https: The voltage in the U o -phase is too high to be applied indefinitely hence, overvoltagebut it allows charging the battery dim in a relatively short time.

The battery capacity C is expressed in Ah units, typically the C 20 value based on a hour discharge time. In this stage, the battery is continued being charged at a constant over voltage U obut the charge current is decreasing.

IUoU battery charging – Wikipedia

The decrease is imposed by the battery. Stage 3 fin called the U-phase or float charge statethe voltage is reduced to a value that is safe to be applied for long periods weeks without significantly reducing the lifetime of the battery.

By using this site, you agree to the Terms of Use and Privacy Policy. The charger provides a constant current, typically the maximum current that the charger is capable of producing.